Setting Fence Stops - Grizzly G0855 Owner's Manual

Setting Fence Stops

Setting Fence Stops
The fence stops simplify the task of adjusting the
fence to 45° inward, 90°, and 45° outward (135°).
Item(s) Needed:
Open-End Wrench 14mm .................................. 1
Sliding Bevel ...................................................... 1
Setting 45° Inward Stop
1.
DISCONNECT MACHINE FROM POWER!
2.
Loosen fence tilt lock, rotate stop block up,
then tilt fence approximately 45° inward onto
stop bolt (see Figure 66).
Stop
Block
Tilt Lock
Figure 66. Fence set to 45° inward.
3. Place sliding bevel set to 45° against fence
and table, as shown in Figure 67.
Sliding Bevel
Set to 45° Inward
Figure 67. Example of adjusting fence to 45°
inward.
Model G0855/G0856 (Mfd. Since 02/19)
Qty
45° Inward
Stop Bolt
Jam Nut
4. Loosen jam nut on 45° stop bolt and adjust
stop bolt until fence is exactly 45° inward
while resting on stop bolt (see Figure 66).
Verify angle, then retighten jam nut.
Setting 90° Stop
1. DISCONNECT MACHINE FROM POWER!
2.
Loosen fence tilt lock, rotate stop block down,
and position fence approximately 90° onto
stop cap screw (see Figure 68).
Jam Nut
Figure 68. Fence set to 90°.
3. Place sliding bevel set to 90° against fence
and table, as shown in Figure 69.
Sliding Bevel
Set to 90°
Figure 69. Example of adjusting fence to 90°.
4.
Loosen jam nut on 90° stop cap screw and
adjust cap screw until fence is exactly 90°
while cap screw is resting on stop block (see
Figure 68). Verify angle, then retighten jam
nut.
90° Stop
Cap Screw
Stop
Block
Tilt Lock
-49-