Grizzly G0855 Owner's Manual page 23

7. Adjust position of table assembly so
cutterhead and motor pulleys are aligned,
and then secure table assembly to stand
with (3) M10-1.5 x 40 standoff hex bolts and
(3) 10mm lock washers (see Figure 13).
Figure 13. Table assembly secured to stand.
8. Adjust feet (see Figure 14) as necessary
until jointer is stable without any rocking or
wobbling.
Adjustable
Feet
Figure 14. Leveling jointer.
Model G0855/G0856 (Mfd. Since 02/19)
9. Loosen motor mount fasteners shown in
Figure 15. DO NOT completely remove
fasteners.
10. Slide motor upward, place V-belt around
cutterhead pulley and motor pulley, then slide
motor down to rest on belt (see Figure 15).
Motor
Pulley
Figure 15. V-belt installed.
V-Belt
-21-