Configuration; Operator Interface - Honeywell DC1000 SERIES Product Manual

3.

Configuration

3.1

Operator Interface

Upper Display
Lower Display
Bar Graph
LEDs
OUT1
OUT2
AT
AL1
AL2
AL3
MAN
PRO
Keys
SET
A/M
SHIFT
UP
DOWN
Upper Display
Lower Display
Bar Graph
4 digits dedicated to display the PV. In configuration mode, this display indicates
the name of parameter.
4 digits dedicated to display the SP. In configuration mode, this display indicates
the value of parameter or the status of parameter selected.
A bargraph of 10 green LEDs' indicates the value of the output in percentage.
Status of 'Output 1'.
Status of 'Output 2'.
When the LED is ON, it indicates the controller is in automatic tuning process .
Status of 'Alarm 1'.
Status of 'Alarm 2'.
Status of 'Alarm 3'.
When the LED is ON, it indicates the controller is in manual mode.
When a program is running, the LED flickers.
When a program is suspended, the LED is ON.
When no program is running, the LED is OFF.
SET key allows moving from one parameter to another or saving a new value of
parameter or a status of parameter changed.
A/M key allows switching from automatic mode to manual mode or from manual
mode to automatic mode.
SHIFT key allows shifting the digits to modify parameters.
UP key allows increasing the value of a digit selected or changing the status of
parameter.
DOWN key allows decreasing the value of a digit selected or changing the status
of parameter.
LEDs
0%
SET key
A/M key
DC1010/1020/1030/1040 Product Manual
20 40 60 80 100%
11
SHIFT key
Up key
Down key