Function Lock - Honeywell DC1000 SERIES Product Manual

3.5

Function Lock

According to the status of the parameter "LCK" in 'Configuration 1' mode, 'access to modes' and
'change of values' can be prohibited.
LCK=0000 MODE ACCESS
LCK=0100 MODE ACCESS
VALUE CHANGE
LCK=0110 MODE ACCESS
VALUE CHANGE
LCK=0001 MODE ACCESS
VALUE CHANGE
LCK=1111 MODE ACCESS
LCK=0101 All access & value changes prohibited except the change of "LCK" status
WARNING
PERSONAL INJURY:
Configuration should be performed only by personnel who are technically competent to do so.
Local Regulations regarding electrical & safety must be observed.
Failure to comply with these instructions could result in death or serious injury.
Access to 'Operation', 'Configuration1 & 2' modes allowe (* Default)
Access to 'Operation' & 'Configuration 1' mode allowed
Every value change in each mode allowed
Access to 'Operation' & 'Configuration 1' mode allowed
Value changes only in 'Operation' mode allowed
Access to 'Operation' mode allowed
Value change of SP (Set Point) allowed only
Access to "Set Up" mode allowed
DC1010/1020/1030/1040 Product Manual
20