Honeywell DC1000 SERIES Product Manual page 22

Main Control (OUT1)
Lower limit of linear output
SET
Main Control (OUT1)
Upper limit of linear output
SET
Sub Control (OUT2)
Lower limit of linear output
SET
Sub Control (OUT2)
Upper limit of linear output
SET
Aux. Output
Lower limit of linear output
SET
Aux. Output
Upper limit of linear output
SET
Timer for Motor Control
SET
WAIT function
SET
Extra SET
SET
ID Number
SET
Baud Rate
SET
SP compensation
SET
PV compensation
SET
Unit of PV & SP
SET
Soft Filter
SET
* Those 2 parameters are only for adjusting the linear signal of control output, not for the limitation of the control output
or any other purpose. Please, DO NOT change the values without Technical Support, see Contacts page.
DC1010/1020/1030/1040 Product Manual
Parameter
16
Description
To adjust the linear control output during the calibration
* DO NOT change the value without technical support
To adjust the linear control output during calibration
* DO NOT change the value without technical support
The same configuration method with 'CL01'
The same configuration method with 'CH01'
The same configuration method with 'CL01'
The same configuration method with 'CH01'
Full actuation time of Time proportional motor control
Range: 5 – 200 sec
To set 'wait' for program operation
0= No wait, others = Wait volume
DO NOT change the value of this parameter
Communication ID number
DO NOT change the value of this parameter
Range: -1000~1000
Range: LSPL~USPL
Selection: C, F, and A (linear)
To adjust PV response time (Range: 0.05 – 1.00)
* The bigger value gives the faster response.