Operation
White Balance
This setting controls the maximum values for each LED color.
1. Go to the White Balance main level.
2. Select Off (uses factory default white setting) or Manual (sets a custom white balance).
a. For Manual, select a color to edit (Red, Green, Blue, or White).
b. Set the maximum value of the selected color (125–255).
c. Repeat steps a-b until the white balance is set as desired.
LED Frequency
This option changes the Pulse Width Modulation (PWM) frequency of the LEDs on the COLORado Panel
Q40.
1. Go to the LED Frequency main level.
2. Select PWM Frequency (600Hz, 1200Hz, 2000Hz, 4000Hz, 6000Hz, or 25Khz).
Fan Mode
This option sets the fan to run automatically when needed or to always run.
1. Go to the Fan Mode main level.
2. Select Auto (fan runs when needed) or On (fan always runs).
Back Light
This setting allows for selection of the amount of time the backlight on the COLORado Panel Q40's display
stays on after the last button is pressed on the control panel.
1. Go to the Back Light main level.
2. Select On (remains on), 10S (10 seconds), 20S (20 seconds), or 30S (seconds).
System Information
This option displays the total number of hours the product has run, the installed software version, and the
product's UID.
1. Go to the Information main level.
2. Select Fixture Hours, Version, UID, or Battery.
Factory Reset
This option restores the COLORado Panel Q40 to factory default settings.
1. Go to the Reset Factory main level.
2. Select No or Yes.
COLORado Panel Q40 User Manual Rev. 1
Page 15 of 20