Table of Contents
Advertisement
O
PERATION
White Balance
This setting allows for selection of the white balance shown by the COLORdash Par-H12 IP when Static >
Manual Color Mixing > Red, Green, Blue, Amber, White, and UV. or the DMX controller's Red, Green,
Blue, Amber, White, and UV faders are set to 255.
1.
Go to the White Balance main level.
2.
Select Manual to continue to adjust the white balance or Off to default to the original factory
setting.
3.
Select a color (Red, Green, Blue, Amber, White, or UV).
4.
Select a color value (125–255).
5.
Repeat for the other colors.
The values of Red, Green, Blue, Amber, White, and UV configured will define the
color temperature shown when the RGBAW+UV faders are set to 255.
Static Fixed Color
The Static Fixed Color mode allows for permanent RGBAW+UV presets without a DMX controller.
1.
Go to the Static main level.
2.
Select Fixed Color.
3.
Select the desired color combination (See
Static Manual Color
The Static Manual Color mode allows for permanent RGBA color mixing without a DMX controller.
1.
Go to the Static main level.
2.
Select Manual Color Mixer.
3.
Select the desired color (Red, Green, Blue, Amber, White, or UV).
4.
Select the color value (000–255).
5.
Repeat for the other colors.
Color Temperature
The color temperature mode allows for permanent white color temperature presets without a DMX
controller.
1.
Go to the Static main level.
2.
Select Color Temperature.
3.
Select the desired color (Warm White 1, Warm White 2, Warm White 3, Neutral White 1,
Neutral White 2, Neutral White 3, Daylight 1, Daylight 2, Daylight 3, or Moving Head White).
Dimmer Profiles
This setting determines how fast the output of the COLORdash Par-H12 IP changes when you modify the
values of the red, green, blue, amber, and dimmer faders. This setting provides four different options to
simulate the dimming curve of an incandescent lighting product.
•
Go to the Dimmer Mode main level.
•
Select a dimmer curve (OFF, Dimmer 1, Dimmer 2, or Dimmer 3).
OFF: The output is proportional (linear) to the dimmer and RGBAW+UV channel
values.
Dimmer 1-3: The output follows the dimmer and RGBAW+UV channel values based
on the corresponding dimmer curve, DIM1 being the fastest.
LED Frequency
This option changes the Pulse Width Modulation (PWM) frequency of the LEDs on the
COLORdash Par-H12 IP.
1.
Go to the LED Frequency main level.
2.
Select PWM Frequency (600Hz, 1200Hz, 2000Hz, 4000Hz, 6000Hz, or 25Khz).
COLORdash Par-H12 IP User Manual Rev. 1
Menu Map
for list of color combination options).
Page 17 of 22
Advertisement
Table of Contents
