Table of Contents
Advertisement
Configuration (Standalone)
Use standalone configuration to operate the product without a DMX controller.
Static Mode
The Static mode allows for permanent dimmer and strobe presets without a DMX controller.
1.
Go to the Static main level.
2.
Select Dimmer or Strobe.
3.
Select the desired value (0–255).
Auto Programs
Auto programs allow for dynamic blinder effects without a DMX controller.
1.
Go to the Auto Show main level
2.
Select the desired auto (Auto 1–5).
3.
Select the desired speed (001–100).
The auto programs cannot be edited.
Master/Slave
The Master/Slave mode allows a group of COLORdash Par-Q12 IP products (the slaves) to
simultaneously duplicate the output of another COLORdash Par-Q12 IP (the master) without a DMX
controller.
To set each of the slaves:
1.
Go to the Master/Slave main level
2.
Select Slave.
To set the master:
1.
Go to the Master/Slave main level
2.
Select Master.
3.
Select an auto program as explained in Auto Programs, or a static setting.
•
The master is the one that runs a program whether in Auto or Static mode.
•
Do not connect a DMX controller to the products configured for Master/Slave
operation. The DMX controller may interfere with signals from the master.
•
The master should be the first product in the daisy chain.
Static Fixed Color
The Static Fixed Color mode allows for permanent RGBAW+UV presets without a DMX controller.
1.
Go to the Static main level.
2.
Select Fixed Color.
3.
Select the desired color combination (See Menu Map for list of color combination options).
Color Temperature
1.
Go to the Static main level.
2.
Select Color Temperature.
3.
Select the desired color (Warm White 1, Warm White 2, Warm White 3, Neutral White 1,
Neutral White 2, Neutral White 3, Daylight 1, Daylight 2, Daylight 3, or Moving Head White).
Static Manual Color Mixer
1.
Go to the Static main level.
2.
Select Manual Color Mixer.
3.
Select the desired color (Red, Green, Blue, or Amber).
4.
Select the color value (000-255).
5.
Repeat for the other colors.
White Balance
This setting allows for selection of the white balance shown by the COLOR dash Par-Q12 IP when Static >
Manual Color Mixing > Red, Green, Blue, Amber, White, and UV. or the DMX controller's Red, Green,
Blue, Amber, White, and UV faders are set to 255.
Page 14 of 19
COLORdash Par-Q12 IP User Manual Rev. 1
O
PERATION
Advertisement
Table of Contents
