Configuration (Standalone); Auto Programs; Master/Slave; White Balance - Chauvet COLORDASH S-PAR 1 User Manual

Operation
Configuration
(Standalone)

Auto Programs

Master/Slave

White Balance

Static Fixed
Color
Static Manual
Color
Color
Temperature
-12-
Use standalone configuration to operate the product without a DMX controller.
Auto programs allow for dynamic RGBA color mixing without a DMX controller.
1. Go to the Auto Show main level.
2. Select the desired auto (Auto 1–5).
3. Select the desired speed (Speed 0–100).
You cannot edit any of the auto programs.
The Master/Slave mode allows a group of COLORdash S-Par 1s (the slaves) to simultaneously
duplicate the output of another COLORdash S-Par 1 (the master) without a DMX controller.
1. Set each of the slaves:
a. Go to the Master/Slave main level.
b. Select Slave.
2. Set the master:
a. Go to the Master/Slave main level.
b. Select Master.
c. Select an auto program as explained in
·
The master is the one that runs a program whether in Auto, or Static Color mode.
·
Do not connect a DMX controller to the products configured for Master/Slave
operation. The DMX controller may interfere with signals from the master.
·
The master should be the first product in the daisy chain.
This setting allows for selection of the white balance shown by the COLORdash S-Par 1 when
the color setting is RGBA and the DMX controller's red, green, and blue faders are set to 255.
1. Go to the White Balance main level.
2. Select Manual to continue to adjust the white balance or Off to default to the original factory
setting.
3. Select a color (R, G, or B).
4. Select a color value (125–255).
5. Repeat for the other colors.
The values of R (red), G (green), and B (blue) configured will define the color temperature
shown when the RGB faders are set to 255.
The Static Fixed Color mode allows for permanent RGBA presets without a DMX controller.
1. Go to the Static main level.
2. Select Fixed Color.
3. Select the desired color (R, G, B, A, GB, R B, RG, RGB, R A, G A, BA, RG A, R BA,
GBA, or RGBA).
The Static Manual Color mode allows for permanent RGBA color mixing without a DMX
controller.
1. Go to the Static main level.
2. Select Manual Color Mixer.
3. Select the desired color (Red, Green, Blue, or Amber.
4. Select the color value (000–255).
5. Repeat for the other colors.
The color temperature mode allows for permanent white color temperature presets without a
DMX controller.
1. Go to the Static main level.
2. Select Color Temperature.
3. Select the desired color (Warm White 1, Warm White 2, Warm White 3, Neutral White 1,
Neutral White 2, Neutral White 3, Daylight 1, Daylight 2, Daylight 3, or Moving Head
White).
Auto Programs, or a static mix of colors.
COLORdash S-Par 1 User Manual Rev. 2