Table of Contents
Advertisement
Setup
Mounting
Before mounting the product, read and follow the safety recommendations indicated in the Safety Notes.
For our CHAUVET Professional line of mounting clamps, go to http://trusst.com/products/.
Orientation
Always mount this product in a safe position, making sure there is adequate room for ventilation,
configuration, and maintenance.
Rigging
Chauvet recommends using the following general guidelines when mounting this product.
•
Before deciding on a location for the product, make sure there is easy access to the product for
maintenance and programming purposes.
•
Make sure that the structure onto which you are mounting the product can support the product's
weight. See the
Technical Specifications
•
When mounting the product overhead, always use a safety cable. Mount the product securely to a
rigging point, whether an elevated platform or a truss.
•
When rigging the product onto a truss, use a mounting clamp of appropriate weight capacity.
•
When power linking multiple products, mount the products close enough for power linking cables to reach.
•
The bracket adjustment knobs allow for directional adjustment when aiming the product to the desired
angle. Only loosen or tighten the bracket knobs manually. Using tools could damage the knobs.
Procedure
The COLORado Panel Q40 comes with a bracket to which you can attach a mounting clamp directly.
Mounting clamps are sold separately. Make sure the clamps are capable of supporting the weight of this
product. Use at least one mounting point per product. For the CHAUVET Professional line of mounting
clamps, go to http://www.trusst.com/products.
Mounting Diagram
Safety Cable
Changing the Filter
To change the filter on the COLORado Panel Q40, remove the magnetic filter frame from the front of the
product and pull back on the magnetic catch. The filter can then be removed and replaced.
COLORado Panel Q40 User Manual Rev. 1
for weight information.
Mounting Clamp
Omega Bracket
Page 7 of 20
Advertisement
Table of Contents
