Table of Contents
Advertisement
Safety Notes
Read all the following safety notes before working with this product. These notes contain important
information about the installation, usage, and maintenance of this product.
This product contains no user-serviceable parts. Any reference to servicing in this
User Manual will only apply to properly trained, certified technicians. Do not open the
housing or attempt any repairs.
All applicable local codes and regulations apply to proper installation of this product.
Personal Safety
•
Avoid direct eye exposure to the light source while the product is on.
•
Always disconnect the product from the power source before cleaning or replacing the fuse.
•
Always connect the product to a grounded circuit to avoid the risk of electrocution.
•
Do not touch the product's housing when operating because it may be very hot.
Mounting and Rigging
•
Do not submerge this product (IP65). Temporary outdoor operation is fine.
•
When using this product in an outdoor environment, use IP65 (or higher) rated power and data
cables. Secure unused power and data ports with attached IP65 covers.
•
CAUTION: When transferring product from extreme temperature environments, (e.g., cold truck to warm,
humid ballroom) condensation may form on the internal electronics of the product. To avoid causing a
failure, allow product to fully acclimate to the surrounding environment before connecting it to power.
•
Not for permanent outdoor installation in locations with extreme environmental conditions. This
includes, but is not limited to:
•
Exposure to a marine/saline environment (within 3 miles of a saltwater body of water).
•
Locations where the normal high or low temperatures exceed the temperature ranges in this
manual.
•
Locations that are prone to flooding or being buried in snow.
•
Areas where the product will be subjected to extreme radiation or caustic substances.
•
Mount this product in a location with adequate ventilation, at least 20 in (50 cm) from adjacent
surfaces.
•
Make sure there are no flammable materials close to the product when operating.
•
When hanging this product, always secure to a fastening device using a safety cable.
Power and Wiring
•
Always make sure you are connecting the product to the proper voltage in accordance with the
specifications in this manual or on the product's specification label.
•
Never connect the product to a dimmer pack or rheostat.
•
Never disconnect this product by pulling or tugging on the power cable.
Operation
•
Do not operate this product if there is damage on the housing, lenses, or cables. Have the damaged
parts replaced by an authorized technician at once.
•
Do not cover the ventilation slots when operating to avoid internal overheating.
•
The maximum ambient temperature is 113 °F (45 °C). Do not operate the product at higher temperatures.
•
The minimum startup temperature is -4°F (-20°C). Do not start the product at lower temperatures.
•
The minimum ambient temperature is -22°F (-30°C). Do not operate the product at lower temperatures.
•
In the event of a serious operation problem, stop using this product immediately!
If your Chauvet product requires service, contact Chauvet Technical Support.
Expected LED Lifespan
LEDs gradually decline in brightness over time, primarily because of heat. LEDs that are arranged in
clusters experience higher operating temperatures than single LEDs. For this reason, operating clustered
LEDs at their fullest intensity significantly reduces the LEDs' lifespan. Under normal conditions, this
lifespan is 40,000 to 50,000 hours. If extending this lifespan is vital, lower the operating temperature by
improving the ventilation around the product, thus reducing the ambient temperature. In addition, limiting
the overall projection intensity may extend the LEDs' lifespan.
Page 2 of 20
Before You Begin
COLORado Panel Q40 User Manual Rev. 1
Advertisement
Table of Contents
