KTM 125 Duke 2017 Owner's Manual page 170

21 TROUBLESHOOTING
Faults
Malfunction indicator lamp lights up
yellow
Engine dies during the trip
ABS indicator lamp lights up
High oil consumption
Headlight and parking light are not
functioning
Turn signal, brake light, and horn are
not functional
Time is not displayed or not correctly
displayed
Battery discharged
Possible cause
Fault in fuel injection system
Lack of fuel
Fuse 1, 3, 4, or 7 is blown
ABS fuse is blown
Large difference in wheel speeds of the
front and rear wheels
Malfunction in ABS
Engine vent hose bent
Engine oil level too high
Engine oil too thin (low viscosity)
Fuse 6 blown
Fuse 4 or 6 blown
Fuse 2 is blown
Ignition was not switched off when
vehicle was parked
Battery is not being charged by alter-
nator
Action
–
Read out the fault memory using the KTM diag-
nostics tool.
–
Refuel. ( p. 81)
–
Change the fuses of individual power consumers.
( p. 136)
–
Change the ABS fuses. (
–
Stop the vehicle, switch off the ignition, and
start it again.
–
Read out the ABS fault memory using the KTM
diagnostics tool.
–
Route the vent hose without bends or change it if
necessary.
–
Check the engine oil level. (
–
Change the engine oil and oil filter, clean the oil
screen. ( p. 156)
–
Change the fuses of individual power consumers.
( p. 136)
–
Change the fuses of individual power consumers.
( p. 136)
–
Change the fuses of individual power consumers.
( p. 136)
–
Recharge the battery.
–
Check the charging voltage.
–
Check the open-circuit current.
168
p. 135)
p. 156)
( p. 132)