KTM 125 Duke 2017 Owner's Manual page 124

14 WHEELS, TIRES
Warning
Danger of accidents There is no braking effect to start with at the rear brake after installing the rear wheel.
–
Actuate the foot brake several times before going on a ride until you can feel a firm pressure point.
Main work
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Change the wheel bearing.
–
Remove the spacers.
–
Clean and grease shaft seal rings
Long-life grease (
–
Clean the thread of the wheel spindle and axle nut.
F00757-10
–
Clean and grease wheel spindle.
Long-life grease (
–
Clean the mating surfaces of the brake caliper support and swingarm.
–
Install the rubber damper and rear sprocket carrier on the rear wheel.
–
Insert the spacers.
–
Position the rear wheel.
The brake linings are correctly positioned.
–
Push the rear wheel forward as far as possible and lay the chain on the rear sprocket.
–
Position the chain guard.
1
and contact surfaces
p. 188)
p. 188)
122
A
of the spacers.