KTM 125 Duke 2017 Owner's Manual page 164

19 CLEANING, CARE
–
Seal the exhaust system to keep water out.
–
First remove coarse dirt particles with a gentle spray of water.
–
Spray very dirty areas with a normal motorcycle cleaner and then clean with a paint-
brush.
Motorcycle cleaner (
Info
Use warm water containing normal motorcycle cleaner and a soft sponge.
Never apply motorcycle cleaner to a dry vehicle; always rinse the vehicle with
401061-01
water first.
If the vehicle was operated in road salt, clean it with cold water. Warm water
would enhance the corrosive effects of salt.
–
After rinsing the motorcycle with a gentle spray of water, allow it to dry thoroughly.
–
Remove the closure of the exhaust system.
Warning
Danger of accidents Moisture and dirt impair the brake system.
–
–
After cleaning, ride the vehicle a short distance until the engine warms up.
Info
The heat produced causes water at inaccessible locations in the engine and on
the brake system to evaporate.
–
Push back the sleeves of the handlebar controls to allow any water that has penetrated
to evaporate.
–
After the motorcycle has cooled off, lubricate all moving parts and bearings.
p. 188)
Brake carefully several times to dry out and remove dirt from the brake lin-
ings and the brake discs.
162