Krautzberger RA 5 Operating Instructions Manual page 32

1. Interrupt the operation (
2. Switch off the system and secure it against being switched on again.
3. Connect cleaning product to input "M".
For design with circulation connection (optional), connect the fluid circulation line to output
"M".
The fluid connections are marked with arrows and must not be interchanged.
4. Switch on the compressed air supply.
5. Where applicable, switch on fluid pressure pump or pressure container for cleaning
product.
6. Begin the spraying procedure by switching on the control air (connection "ST A").
7. Spray until the cleaning product runs clear.
8. Interrupt the supply of cleaning product by switching off the fluid pressure pump or the pres-
sure container.
9. Blow out cleaning product residue by briefly switching on the control air.
10. Switch off the compressed air supply and secure it against a restart.
11. Clean the outside of the device with a cloth dipped in cleaning product.
12. Remove fluid and air nozzle (
nozzle' on page 33) and clean with a soft brush. Do not use hard or sharp-edged objects.
We recommend our brush set. See the last page for contact information.
13. Slightly grease sliding parts with special Krautzberger grease.
The special grease can be purchased from Krautzberger GmbH (contact data see last page).
GB–32
Operating instructions
Ä Chapter 7.6 'Shutting down' on page 29).
Ä Chapter 8.4 'Changing the material nozzle and the air
T-Dok-449-GB-Rev.7
mail@krautzberger.com, www.krautzberger.com