Operating The Splendimo Triplo 801 - LELY Splendimo Triplo 801 Operator's Manual

8
4 OPERATING THE SPLENDIMO
TRIPLO 801
!
In addition to the F/FC manual.
4.1 From transport position to working position
Make sure that there is enough room to lower the machine
!
and that there is no one standing in this "Danger-zone"
• Open the ball-valves on the frame cylinders
• Lower the frame cylinders. The two sides are coupled but
due to weight distribution one side will always be first to
lower
• Make sure that 12 V power is applied to the control box
• Set the switch on the control box to middle position
• Open the ball-valves on the mowers and lower these
• Adjust the mowing height (see mowing height adjust-
ments)
• Bring the TRIPLO frame to working height: adjust the
three point hitch until the bottom side of the mower
headstock is approx. 80 cm above ground level (see F/FC
manual chapter 4)
• Now use the machines the same as using one F/FC mower
(see F/FC manual chapter 5).
4.2 Mowing height adjustments
The top links that connect the mowers to the frame are not
meant for adjusting the mowing height. They are can however
be used to synchronize the mowing height of the left and right
mower if needed.
To adjust mowing height adjust the top link that connects the
TRIPLO frame to the tractor. Make sure that the top link is
not extended too far.