Test Run - Grizzly G0765 Owner's Manual

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
To test run machine:
1.
Set spindle direction switch to neutral ("0"
position), and turn variable speed dial all the
way counterclockwise to "0".
Emergency
Stop Button
Variable Speed Dial
Set to "0"
Figure 15. Headstock controls.
Model G0765 (Mfd. Since 5/15)
Spindle Direction
Switch Set to "0"
2. Shift high/low range lever on back of lathe to
LOW, and feed direction lever to neutral (see
Figure 16).
High/Low
Range Lever
Feed Direction Lever
UP (Clockwise Rotation)
CENTER (Neutral)
DOWN (CCW Rotation)
High/Low
Range Lever
HIGH
Figure 16. Lever settings.
3.
Make sure chuck and jaws, if installed, are
secure (see Chuck Installation on Page 26).
Note: If a chuck is not installed on the lathe,
you do not need to install one for this test run.
Feed
Direction
Lever
LOW
-19-