Test Run - Grizzly T32536 Owner's Manual

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
The test run consists of verifying the following:
1) The motor powers up and runs correctly, and
2) the safety disabling mechanism on the switch
works correctly.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
To test run machine:
1. Clear all setup tools away from machine.
2.
Turn spindle speed dial all the way counter-
clockwise to help prevent accidental start-up.
3.
Connect machine to power supply.
-16-
4. Verify machine is operating correctly by mov-
ing ON/OFF paddle switch up, then slowly
turning spindle speed dial clockwise.
— When operating correctly, machine runs
smoothly with little or no vibration or rub-
bing noises.
— Investigate and correct strange or unusu-
al noises or vibrations before operat-
ing machine further. Always disconnect
machine from power when investigating or
correcting potential problems.
5.
Turn spindle speed dial all the way counter-
clockwise.
6. Turn machine OFF.
7. Remove switch disabling key (see Figure 10).
Figure 10. Removing switch disabling key from
paddle switch.
8.
Try to start machine with paddle switch.
— If machine does not start, switch disabling
feature is working correctly.
— If machine does start, immediately discon-
nect power to machine. Switch disabling
feature is not working correctly. Call Tech
Support for help.
Congratulations! The Test Run is complete.
Model T32536 (Mfd. Since 10/20)