Check Gearbox Oil; Test Run - Grizzly G9972Z Owner's Manual

Check Gearbox Oil

It is critical that you make sure there is oil in the
feed rate gearbox before proceeding with the
test run. Refer to the Lubrication instructions on
Page 51 for more details on which type of oil to
use, how much to use, and where to put it.
GEARBOXES MUST
BE FILLED WITH OIL!
NO OIL SHIPPED WITH
MACHINE!
Refer to the Lubrication
Section in this Manual
for Recommended
Oil Type.
-18-

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
The Test Run consists of verifying the following: 1)
The motor powers up and runs correctly.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
To test run machine:
1. Clear all setup tools away from machine.
2. Perform all lubrication procedures as instruct-
ed in the Lubrication subsection on Page 51.
Model G9972Z (Mfd. Since 03/20)