Imbalance Detection - Fagor Edesa 2006 Technical Manual

t e c h n i c a l

3.6.3.- Imbalance Detection

DETECTION LEVEL WHEN WASHING
DETECTION LEVEL FOR LOW SPIN
DETECTION LEVEL FOR HIGH SPIN
Note: These data are for a belt tension of 120 Hz and a SELNI motor
Function in the stop programme end
While PN is kept off
(empty)
While PN is kept on
(full)
Memory function for power cuts
Maintains programme memory for at least 2 hours.
When spinning, the step times are always reset
Changes in the programme selector
A programme change means that the programme will start again from the starting
position.
Description of operation
Door lock OFF & Pump OFF.
Power failure: It is ready to start a new programme
(pause status).
It is in PAUSE status.
When Start is pressed: restarts a new programme
Door lock OFF & Pump in cycles:
(1 minute On , 1 minute OFF)
In case of overflow, the first pump cycle is:
(6 minutes On , 1 minute OFF)
Power failure: stays in the same situation.
It is always in START status.
When Start is pressed: stays in the same situation.
Will show fault F2 while this condition exists.
18
650 gr.
750 gr.
1520 gr.