Flot/Anti-Crease; Programme Progress; Power Failure - Fagor Edesa 2006 Technical Manual

t e c h n i c a l
Description of operation
3.1.4.- Flot/Anti-crease Option
- With this option the programme stops before emptying the last rinse; for the
programme to continue, the Flot option must be unlocked
Note: The wash options must always be selected after selecting the wash
programme. A change of programme during the selection, or after the wash has
been started, cancels the options which were previously selected, and only the new
programme's spin speed is lit up.

3.1.5.- Programme progress

When the programme has started, the screen can
display the current wash phase, as well as the
remaining time. As the programme continues, the
active phases will be displayed successively in the
upper part of the screen. The remaining program-
me time is also displayed in the screen. It is upda-
ted periodically, but not minute-by-minute.
Any option button may be selected, as long as
the wash phase in which it takes effect has not passed, and when the programme
permits that option. Pressing the delay button during the wash has no effect on the
washer-dryer. Pressing the Start/Pause button during the wash puts the washer in
the PAUSE state.
Important: If during the wash and dry cycle the programme is changed using
the selector, the washer-dryer is left in the PAUSE state, and the programme is
annulled. To add or remove an article, press the start/pause button and make sure
that the water is not above the door overfl ow level, and that the interior temperature
is not high. Press the start/pause button again to re-start the washer from the same
phase of the cycle in which it was stopped.

3.1.6.- Power failure

When the supply returns after a power failure, the washer continues to work as
normal, from the point at which it stopped (its memory lasts a few hours). The same
thing happens if the ON/OFF button is pressed.
7