Table of Contents
Advertisement
Pausing a Build
When the Pause Build button is active, click on it to pause the build and display options .
Resume the build as soon as possible after you pause it .
CLICK THIS PAUSE BUILD BUTTON . . .
Resume Build
Enter Next Stage
Terminate Build
Change Profiles/Prime Cycle
Modifying a Build in Progress
Make changes during a build with the Build Modify dialog box .
To display it, click the Change Parameter button; if the build is paused, click the Change Profiles/Prime Cycle button in the
Pause Build dialog box .
Modifying Part and Build Profiles
Click the Modify Build Profile or Modify Part Profile button to display a profile editor dialog box. Modify parameters as
described in the 3D Sprint Help .
NOTE: You can find definitions of the parameters in the 3D Sprint Help.
In most respects these dialog boxes work just as they do in the 3D Sprint software, with the following differences:
•
Settings for Z levels below the current are yellow and cannot be changed.
•
The current Z level is displayed as a green vertical line in the parameter chart.
•
In the Build Profile Editor, a new button appears. Use this button to make a profile change at the current Z level. Click the
button and a new row appears in the current build stage . Click in the Value column and enter a value, then click Apply .
When the system applies the value, it updates the row to the current Z level.
•
If you make changes near the current Z, the system may not be able to apply them. If you do not get the message The
parameter change has been applied after clicking Apply, try again at a higher Z. (There is no message when the attempt
fails .)
3D Systems, Inc.
Continue the build .
Move from Warmup stage to Build stage, or Build stage to Cooldown .
Stop the build . If you terminate a build when the system is in the Build stage,
and you do not want to restart the build from the termination point, remove
any parts from the print bed and review the build packet in 3D Sprint . Make any
changes that can improve the build .
Modify a profile, add/delete parts, or run a prime cycle.
24
TO DO THIS . . .
p/n 76-D020 Rev. A
Advertisement
Table of Contents
