Table of Contents
Advertisement
Introduction
The Servo System 1S-Series Startup Guide (hereinafter, may be referred to as "this Guide")
describes the procedures for installation and setup of a 1S Servo Drive, where an
NJ/NX-series CPU Unit is used in combination with1S-series AC Servomotors/Servo Drives and
NX-series Safety Unit, by using the Sysmac Studio. A simple installation model is used for the
discussion. You can perform the procedures that are presented in this Guide to quickly gain a
basic understanding of a 1S-series AC Servomotors/Servo Drives.
This Guide does not contain safety information and other details that are required for actual use.
Thoroughly read and understand the manuals for all of the devices that are used in this Guide to
ensure that the system is used safely. Review the entire contents of these materials, including
all safety precautions, precautions for safe use, and precautions for correct use.
Intended Audience
This Guide is intended for the following personnel.
Personnel in charge of introducing FA systems
•
Personnel in charge of designing FA systems
•
The personnel must also have the following knowledge.
Knowledge of electrical systems (an electrical engineer or the equivalent)
•
Knowledge of NJ/NX-series CPU Units
•
Knowledge of NX-series Safety Units
•
Knowledge of Servomotors/Drives
•
Knowledge of operation procedure of Sysmac Studio
•
Applicable Products
This Guide covers the following products.
CPU Units of NJ/NX-series Machine Automation Controllers
•
Automation Software Sysmac Studio
•
1S-series Servomotors/Servo Drives
•
NX-series EtherCAT Coupler unit
•
NX-series Safety controller
•
Special Information
The icons that are used in this Guide are described below.
Precautions for Correct Use
Precautions on what to do and what not to do to ensure proper operation and
performance.
Additional Information
Additional information to read as required.
This information is provided to increase understanding or make operation easier.
3
Advertisement
Table of Contents
