■ Setting the axis
This section describes how to add the axis that is used to control the Servo Drive, assign it to the Servo
Drive, and set the axis parameters.
1.
Right-click MC_Axis000 (axis 0) in the Multiview Explorer and select Edit from the
menu.
Axis 0 is added to the Multiview Explorer. The axis is added as MC_Axis000.
2.
Right-click MC_Axis000 (axis 0) in the Multiview Explorer and select Edit from the
menu.
The Axis Basic Settings are displayed on the Axis Parameter Settings Tab Page in the Edit
Pane.
43