MULTIQUIP WHITEMAN SERIES Operation And Parts Manual page 33

ADDING HYDRAULIC OIL
1. Check the hydraulic oil level in the hydraulic oil tank,
by reading the hydraulic oil sight glass (Figure 39)
mounted on the hydraulic oil tank.
NORMAL
OPERATING
LEVEL
Figure 39. Hydraulic Oil Sight Glass
2. If the hydraulic oil level is low, fill to the proper level with
EXXON/MOBIL NUTO H 46 or equivalent.
3. To gain access to the hydraulic oil tank filler hole, the
tub (Figure 40) must be placed in the dump position
(vertical).
4. Start the engine as outlined in the starting procedure,
then place the tub in the dumping position.
TUB (BUCKET)
TUB (BUCKET)
Figure 40. Tub Dump Position
Hydraulic Oil Access
WBH-16EF CE POWER BUGGY • OPERATION AND PARTS MANUAL — REV. #0 (09/19/18) — PAGE 33
DUMP
CONTROL
LEVER
DUMP PEDAL
5. Use the tub support rod to support the tub, then turn
the engine OFF.
6. Remove the two bolts that secure the access
cover(Figure 41) to the buggy frame.
Figure 41. Access Cover
7. Lift up on access door and secure latch.
8. Remove the hydraulic oil filler cap (Figure 42), and add
hydraulic oil as required. Fill to the normal operating
mark as indicated on the hydraulic oil sight gauge.
HYDRAULIC
OIL TANK
Figure 42. Adding Hydraulic Oil
NOTICE
In climates where temperatures are below 35°F (1.6°C),
hard starting may occur. In these cases, the hydraulic oil
should be switched to a thinner 15 weight hydraulic fluid.
MAINTENANCE