MULTIQUIP WHITEMAN SERIES Operation And Parts Manual page 31

4. Clean foam element in warm, soapy water or
nonflammable solvent. Rinse and dry thoroughly. Dip
the element in clean engine oil and completely squeeze
out the excess oil from the element before installing.
5. DO NOT pour any type of oil into the foam element.
Figure 31. Cleaning Foam Element
6. Wipe dirt from the inside of the air cleaner cover, using
a moist cloth. Be careful not to let any dirt or debris
enter the air chamber that leads to the carburetor.
7. Reinstall the foam air filter element and paper air filter
element.
8. Reinstall air cleaner cover.
CHANGING ENGINE OIL (100 HOURS)
1. Drain the engine oil when the oil is warm as shown in
(Figure 32).
2. Remove the oil drain bolt and sealing washer and allow
the oil to drain into a suitable container.
Figure 32. Draining Engine Oil
3. Reinstall drain bolt with sealing washer and tighten
securely.
4. Replace engine oil with recommended type oil as
listed in Table 5. For engine oil capacity, see Table 3.
DO NOT over fill.
WBH-16EF CE POWER BUGGY • OPERATION AND PARTS MANUAL — REV. #0 (09/19/18) — PAGE 31
IN-LINE FUEL FILTER (200 HOURS)
1. Place the fuel tank ON/OFF valve lever (Figure 33) in the
OFF position.
Figure 33. Fuel Tank Valve Lever (OFF)
2. Replace the engine in-line fuel filter (Figure 34) every
200 hours. When replacing filter pay close attention to
the orientation of the arrows.
Figure 34. In-Line Fuel Filter
3. Return the fuel tank ON/OFF valve (Figure 35) to the
ON position.
OFF
Figure 35. Fuel Tank Valve Lever (ON)
Oil And Fuel Lines
„ Check the oil and fuel lines and connections regularly
for leaks or damage. Repair or replace as necessary.
„ Replace the oil and fuel lines every two years to maintain
the line's performance and flexibility.
MAINTENANCE
OFF
OFF
ON