MULTIQUIP WHITEMAN SERIES Operation And Parts Manual page 24

PRE-CHECK
1. Engage the parking brake lever (Figure 18) and attempt
to rock the buggy back and forth. If the wheels turn
during the rocking motion, adjust the brakes as outlined
in the maintenance section of this manual.
PARKING BRAKE LEVER SET
PARKING BRAKE LEVER RELEASED
Figure 18. Parking Brake Lever
2. Place the engine's throttle lever (Figure 16) in the slow
(idle) position.
3. Check the speed control lever (Figure 19) located on
the right side of the handle bar. The speed control
should work freely when squeezed by hand, and return
to the neutral position when released.
Figure 19. Speed Control Lever
PAGE 24 — WBH-16EF CE POWER BUGGY • OPERATION AND PARTS MANUAL — REV. #0 (09/19/18)
SPEED CONTROL
LEVER
PARKING BRAKE/DIRECTION LEVER
Before the power buggy can be put into operational use,
it is best to perform a test run to make certain that all
components are functioning properly.
1. Place the buggy on flat solid ground.
2. Engage the parking brake lever.
3. Place the engine's throttle control (Figure 16) in the
SLOW (idle) position.
4. Place the power buggy's direction lever (Figure 20) in
the forward direction.
Figure 20. Direction Lever
5. Slowly squeeze the speed control lever slightly
(Figure 19), for a short period of time to test the brake
holding capacity. If the buggy moves forward, adjust
the brakes as outlined in the maintenance section of
this manual.
6. If the buggy does not move forward, release the
speed control, and disengage the parking brake. If
the buggy creeps forward or reverse while the parking
brake is disengaged, the machine will require service
adjustment of the pump control lever as outlined in the
maintenance section of this manual.
OPERATION
FORWARD
NEUTRAL
REVERSE
TRAVEL
CONTROL
LEVER