Wacker Neuson ARFU 36/6/120 Operator's Manual page 11

Starting the machine
Observe the safety information and warning notices located on the machine and
in the operator's manual.
Never attempt to start a machine that requires maintenance or repairs.
Start the machine as described in the operator's manual.
Avoid body contact with grounded components.
Vertical stability
Always make sure that you stand firmly when working with the machine. This ap-
plies particularly when working on scaffoldings, ladders, uneven or slippery
floors etc.
Caution with hot parts
Do not touch the machine during or shortly after operation. Some parts can be-
come very hot and can cause severe burns.
Do not use components of to machine for climbing on or holding onto
Never use the protective hose, power cable or other components of the machine
for climbing on or holding onto.
Switching off the machine
Switch off the machine and pull the plug out of the plug receptacle in the following
situations:
Before breaks.
If you are not using the machine.
Store the machine or put it down in such a way that it cannot tilt, fall down or slip.
Disassembling the machine
Before disassembling the machine, wait until it has cooled down completely.
Storage
Set the machine down or store it securely so that it cannot tilt, fall down or slip.
Storage location
After operation, allow the machine to cool and then store it in a sealed-off, clean
and dry location protected against frost and inaccessible to children.
2 Safety
11