AEG BSE574221M User Manual page 32

32 www.aeg.com
2. Pull the rear end of the shelf support
away from the side wall and remove
it.
1
Install the removed accessories in the
opposite sequence.
11.4 Pyrolysis
CAUTION!
Remove all accessories and
removable shelf supports.
Do not start the Pyrolysis if
you did not fully close the
oven door. In some models,
the display shows "C3"
when this error occurs.
WARNING!
The oven becomes very hot.
There is a risk of burns.
CAUTION!
If there are other appliances
installed in the same
cabinet, do not use them
when the Pyrolysis function
operates. It can cause
damage to the appliance.
1. Wipe out the cavity with a wet, soft
cloth.
2. Clean the inner side of the door with
hot water, so that the residues do not
burn from the hot air.
3. Set the Pyrolysis function. Refer to
"Daily use" chapter, "Oven
Functions".
4. When
set the pyrolysis duration:
2
flashes, press or
Option
P1
P2
Press or turn the knob for the
temperature to start the pyrolysis.
You can use the END function to delay
the start of the cleaning.
During the pyrolysis the oven lamp is off.
5. When the oven is at the set
temperature, the door locks. The
display shows
heat indicator until the door unlocks.
To stop pyrolysis before it is
completed, turn the knob for the
oven functions to the off position.
6. When pyrolysis is completed, the
display shows the time of day. The
oven door stays locked.
7. When the oven is cool again, the
door unlocks.
11.5 Cleaning reminder
To remind you that the pyrolysis is
necessary, PYR flashes in the display for
10 seconds after each activation and
deactivation of the oven.
The cleaning reminder
goes out:
• after the end of the
pyrolysis.
• if you press
the same time while PYR
flashes in the display.
11.6 Cleaning the water tank
WARNING!
Do not put water into the
water tank during the
cleaning procedure.
to
Description
Light clean-
ing. Duration:
1 h 30 min.
Normal clean-
ing. Duration:
2 h 30 min.
and the bars of the
and at