Table of Contents
Advertisement
14
www.aeg.com
When the meat is at the set core
temperature, the symbol for the core
temperature sensor
core temperature flash. The signal
sounds for 2 minutes.
5. Press any button or open the oven
door to stop the signal.
6. Remove the plug of the core
temperature sensor from the socket.
Remove the meat from the oven.
7. Turn off the oven.
WARNING!
Be careful when you remove
the tip and plug of the core
temperature sensor. The
core temperature sensor is
hot. There is a risk of burns.
Every time you put the core temperature
sensor in the socket, you need to set the
core temperature time again. You cannot
select the duration and end time.
When the oven calculates the provisional
duration time for the first time, the
symbol
the calculation ends, the display shows
the duration of the cooking. Calculations
run in the background during the
cooking and the duration value in the
display is updated if necessary.
You can change the temperature at any
time during the cooking:
1. Press
• one time - the display shows the
set core temperature; if desired, it
can be modified within 5 seconds.
• two times - the display shows the
current oven temperature.
• three times - the display shows
the set oven temperature; if
desired, it can be modified within
5 seconds. This info is available
only during the heating up phase.
2. Use the knob for the temperature to
change the temperature.
8.2 Inserting the accessories
Wire shelf:
Push the shelf between the guide bars of
the shelf support and make sure that the
feet point down.
and the default
flashes in the display. When
:
Deep pan:
Push the deep pan between the guide
bars of the shelf support.
Wire shelf and deep pan together:
Push the deep pan between the guide
bars of the shelf support and the wire
shelf on the guide bars above.
Small indentation at the top
increase safety. The
indentations are also anti-tip
devices. The high rim
around the shelf prevents
cookware from slipping of
the shelf.
Hide quick links:
Advertisement
Table of Contents
