Table 3-5 Fault Numbers For "Cannot Process Request" Response - Siemens COMBIMASTER 411 Operating Instructions Manual

COMMUNICATION
Table 3-5
No.
0 Illegal parameter number (PNU)
1 Parameter value cannot be modified
2 Minimum/maximum not reached/exceeded
3 Faulty subindex
4 No array
5 Incorrect data type
6 Setting not allowed (resetting only)
7 Descriptive element cannot be modified
11 No status as master control
12 Key word missing
17 Request cannot be processed due to operating
state
101 Parameter number currently deactivated
102 Channel not wide enough
104 Illegal parameter value
106 Request not implemented
200/ Modified minimum/maximum not
201 reached/exceeded
204 Available access authorization does not cover
modification of parameters
26
Fault numbers for "Cannot process request" response
PROFIBUS Communication Module
Meaning
Parameter does not exist
Parameter is a read-only parameter
-
-
Single parameter has been accessed with
array request and subindex > 0
Mix-up between word and double word
-
Description can never be modified with
MICROMASTER 4
Modification request without status as master
control (see P0927)
-
Current inverter status is not compatible with
the received request
Dependent on inverter status
Communication channel too small for
response
Parameter permits only certain values
After request identifier 5, 10, 15
Minimum/maximum can be further limited in
operation
-
Issue 03/02
Operating instructions
6SE6400-5AV00-0BP0