Connection To Profibus-Dp; Installing The Profibus-Option Module; List Of Accessories; Preparation Of Inverter Terminal Housing - Siemens COMBIMASTER 411 Operating Instructions Manual

Issue 03/02
4

Connection to PROFIBUS-DP

4.1

Installing the PROFIBUS-option module

Warning
!
♦
Make sure that the MICROMASTER 411/COMBIMASTER 411 inverter is
isolated from the electrical supply before you install or remove the
PROFIBUS-option module.
!
Cautions
♦
Do not knock out cable gland blanking plates unless inverter 'electronics'
(Filter & I/O boards) have been removed!
♦
The inverter and PROFIBUS module electronics contain static sensitive
devices therefore precautions must be taken against electrostatic discharge
(ESD) when handling the separated inverter assembly. These include not
touching the internal surfaces of the inverter and ensuring that personnel
are earthed while handling the unit. The terminal housing, including Filter
and I/O modules, contain no sensitive components and therefore no special
handling precautions are required when separated.
4.1.1

List of Accessories

A list of the accessories provided with the PROFIBUS Communications Module is
given in Table 4-1 below.
Table 4-1
1. 1-off Gland Hole
Blanking Cover
2. 2-off M16 Cable Gland
3. 2-off U-clamp (for earth
connection)
4. 1-off Option Gland
Fixing Plate
5. 2-off O-ring Sealing
Gasket
4.1.2

Preparation of Inverter Terminal Housing

To mount the PROFIBUS-DP options module on the inverter body the following
procedure should be performed:
1. If the Inverter has already been fitted unscrew the four crosshead captive
screws (1) on the inverter cover (as shown Figure 4-1).
PROFIBUS Communication Module
6SE6400-5AV00-0BP0
List of Accessories
6.
7.
8.
9.
10.
11.
Operating instructions
4-off M4 x 20 Screws
1-off Communication Link
Cable
1-off Comms Link
Connector Retention Clip.
8-off Jumpers
1-off Option Gland fixing
Plate with Earth Lead
6-off M4 x 10 Screws
CONNECTION
31