AEE AP10 User Manual

AEE AP10 User Manual

Aerial photography equipment
Hide thumbs Also See for AP10:

Advertisement

Aerial Photography Equipment
Professional·Advanced
Unprecedented
Technology
User's Manual
Please read this Manual carefully before use,
and keep it handy for future reference.

Advertisement

Table of Contents
loading

Summary of Contents for AEE AP10

  • Page 1 Aerial Photography Equipment Professional·Advanced Unprecedented Technology User’s Manual Please read this Manual carefully before use, and keep it handy for future reference.
  • Page 2: Table Of Contents

    CONTENTS Statement ........................1 Product Introduction ....................1 Precautions for Use of Aerial Photography Equipment ........... 1 Precautions for Use of Airborne Camera ..............2 Precautions for Use and Charging of Battery ............3 Charging ........................3 Connect Battery to Charger ......................4 List of Components ......................
  • Page 3 How to Use Wi-Fi ......................18 Install App on Mobile Phone ......................18 Connect App ..........................19 Instructions on How to Operate Wi-Fi Control Interface ............... 19 Instructions on Use of the Repeater ..................... 20 Alarm Sounds ......................21 Specification ....................... 22 Troubleshooting ......................
  • Page 4: Statement

    1. Never use this product for any and all illegal activities; or, Shenzhen AEE Aviation Technology Co., Ltd. shall assume no liability for any consequences resulting therefrom. 2. Never use this product in any and all no-fly zones; or, Shenzhen AEE Aviation Technology Co., Ltd. shall assume no liability for any consequences resulting therefrom.
  • Page 5: Precautions For Use Of Airborne Camera

    Aerial Photography Equipment Professional·Advanced * Do not use the aerial photography equipment in complex electromagnetic environments, because its communication will be affected in such environments, further resulting in abnormal Wi-Fi and remote control communications. * If a mobile phone is connected for image preview, do not answer any incoming calls whenever possible. * Keep away from humid environments;...
  • Page 6: Precautions For Use And Charging Of Battery

    Aerial Photography Equipment Professional·Advanced * Please stop using the device immediately when smoke or smelly gas comes out of the device. * When this device is used to shoot important scenes, please perform test shooting several times before actual shooting, to make sure the device is in normal working condition. Precautions for Use and Charging of Battery * Do not immerse the battery into water;...
  • Page 7: Connect Battery To Charger

    Aerial Photography Equipment Professional·Advanced Connect Battery to Charger Connect the battery to the charger according to the steps shown below: Step Illustration Description As shown in the figure, insert the plug Step 1: at one end of the charger by aligning it with the battery.
  • Page 8: Guide For Components

    Aerial Photography Equipment Professional·Advanced Repeater adapter: 1pc Mobile phone stand: Repeater: 1pc Propeller guard: 4pcs Cross-head screwdriver: 1pc M3.0×10 screw: 16pcs Wrench: 1pc User’s Manual Battery of remote control: Propeller blade Long hexagonal screw: 4pcs (AA) (4pcs/set): 2 sets Notice: The accessories of actual products may vary slightly, and the above figures are for reference only. Guide for Components - 5 -...
  • Page 9: Install Propellers

    Aerial Photography Equipment Professional·Advanced Propeller Motor Airborne camera Undercarriage Propeller guard Right front light Left front light (green) (green) TF card slot Right rear light Left rear light (red) (red) Tail light (red) Battery door Power switch Install Propellers There are two clockwise propellers and two counter-clockwise propellers. The propeller caps have two colors: black and silver.
  • Page 10 Aerial Photography Equipment Professional·Advanced Points for attention: (1) The propellers are designed with automatic tightening function; please do not over-tighten them during installation, and do not use screw adhesive. (2) Please make sure the propellers with black and silver caps are installed in right positions. (3) Since the propeller blades are thin, it is suggested that gloves should be worn during installation in order to avoid accidental injury.
  • Page 11: Install Propeller Guards

    Install Propeller Guards Please install the propeller guards according to the steps shown below: Prepare AP10 aerial photography equipment (1 set), propeller guard (4pcs), M3.0×10 screw (8pcs), and cross-head screwdriver (1pc). Use the screwdriver to remove the two screws (M3.0×6) on the motor, as shown in the ovals in the figure below.
  • Page 12: Preparations Before Take-Off

    Preparations before Take-off Before use of AP10, please first install the propellers. Check the entire equipment to see if it is complete and secure and if any screw is loosened. Please install the clockwise and counter-clockwise propellers properly, and make sure the aerial photography equipment and the remote control have sufficient battery level.
  • Page 13: Description Of Buttons

    Aerial Photography Equipment Professional·Advanced Description of Buttons Name of button Description of function Slide switch S1 1. Up (OFF): non-lock normal flight; 2. Middle (CL): course lock; 3. Down (HL): home lock 1. Up (OK): normal flight; 2. Middle (NULL): reserved; 3. Down (ADJ): enable joystick Slide switch S2 adjustment 1.
  • Page 14: Pairing Of Aerial Photography Equipment

    Aerial Photography Equipment Professional·Advanced Install the batteries in the remote control; slide the power switch rightwards to turn it ON; at this moment, the left power indicator (red) turns on, and the right recording indicator (blue) turns off 3s after turning on. Pairing of Aerial Photography Equipment The aerial photography equipment has undergone pairing before delivery, so it is unnecessary to carry out pairing again.
  • Page 15 Aerial Photography Equipment Professional·Advanced The following figure shows the six planes that need to be calibrated: 2. Calibration of gyroscope: Place the aerial photography equipment on a horizontal plane, and keep it away from vibration sources; at this moment, the front lights (green) turn constantly on. About 1s later, turn the remote control joysticks to an upper toe-out shape (as shown in the figure) until the rear lights (red) begin to flash, and then loosen the joysticks;...
  • Page 16: Start The Aerial Photography Equipment

    Aerial Photography Equipment Professional·Advanced Turn the left joystick to the upper left corner Turn the right joystick to the upper right corner 3. Calibration of compass: Place the aerial photography equipment on a horizontal plane; at this moment, the rear lights (red) turn constantly on.
  • Page 17: Trial Flight

    Aerial Photography Equipment Professional·Advanced “MC” position (manual fly control mode). 3. To switch the fly mode of the aerial photography equipment to GPS mode (if GPS satellite search is normal) when the flight in manual mode is normal, please first keep the equipment hovering, and then turn S4 to “AC” position for flight in GPS mode.
  • Page 18 Aerial Photography Equipment Professional·Advanced moment, unlocking should be first carried out; turn the joysticks to a lower toe-out shape and loosen them after 3s. Motor shutdown: The aerial photography equipment has three modes for motor shutdown: motors will be shut down (immediately) when the joysticks are turned to a lower toe-out shape;...
  • Page 19: Direction Control

    Aerial Photography Equipment Professional·Advanced 6. In the manual fly mode (MC), when the nose and tail of the aerial photography equipment cannot be discriminated because the equipment is beyond your sight, the slide switch S4 can be turned up to “AC”; then, the aerial photography equipment will stay in the auto hover state;...
  • Page 20 Aerial Photography Equipment Professional·Advanced Climb Upwards Rise The motor speed and the propeller speed increase. The climbing speed increases with Horizon as the joystick turning angle Turn the left joystick forwards, and increases. keep the right joystick in the original position.
  • Page 21: How To Use Wi-Fi

    How to Use Wi-Fi AP10 camera device is designed with built-in Wi-Fi. You can connect a smartphone to AP10 airborne camera to realize remote control over the airborne camera. First of all, please install the app provided by AEE on your mobile phone.
  • Page 22: Connect App

    Aerial Photography Equipment Professional·Advanced normal working status. Use a needle-like object to press the “RESET” button of the repeater until the WiFi signal indicator turns off; then loosen the “RESET” button. Wait for about 30s; then the WiFi signal indicator (blue) flashes (indicating the repeater has acquired the SSID and MAC address of the airborne DV), and the repeater enters the binding state;...
  • Page 23: Instructions On Use Of The Repeater

    Aerial Photography Equipment Professional·Advanced 4. Setting Click on the setting icon “ ” to change the parameters of recording setting, photographing setting and parameter setting. (1) Recording setting Click the “Resolution” option to set the desired video resolution: (PAL system) 1920×1080P 025f, 1280×0960P 048f/025f, 1280×0720P 050f/025f, 0848×0480P 100f/050f;...
  • Page 24: Alarm Sounds

    Aerial Photography Equipment Professional·Advanced Usable duration: 3.4h Charging duration: <2h 1.4 Binding between the repeater and the airborne camera The repeater is a wireless communication device working at 2.4GHz frequency band, which is used to increase the effective communication distance between the mobile device and the aerial photography equipment. In an open field without interference, the effective communication distance can reach 300m or more.
  • Page 25: Specification

    Aerial Photography Equipment Professional·Advanced photography equipment beep beep --- beep beep… continuous Level 1 alarm for low battery of the aerial The arm lights flash slowly with beep sounds: beep --- beep --- photography equipment beep… continuous Alarm for low battery of the remote control Beep --- beep beep…...
  • Page 26: Protection Mechanism

    Aerial Photography Equipment Professional·Advanced started properly as required (2) Check the power battery of the aerial photography equipment to make sure the battery level is high enough. Protection Mechanism 1. During flying in the manual mode, when it is beyond the operating range, the aerial photography equipment will enter the protection mode, and automatically fly back to the take-off position and land.
  • Page 28 Popular in European, National Hi-tech American and Asian Patented Shenzhen Top Guangdong Famous Markets with Enterprise Technologies Brand Trademark Self-owned AEE Brand Please read this Manual carefully before use, and keep it handy for future reference.
  • Page 29 Aerial Photography Equipment Professional·Advanced Created in China Made in Shenzhen Add.: AEE Hi-Tech Park, Yangguang Industrial Area, Xili Town, Nanshan District, Shenzhen, P.R. China Tel.: 0755-29518998 Fax: 0755-27358999 - 2 -...
  • Page 30 FCC Information and Copyright This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

Table of Contents