Install Propeller Guards; Install Battery - AEE AP10 User Manual

Aerial photography equipment

Hide thumbs Also See for AP10:

Table of Contents

AEE

Aerial Photography Equipment

Professional·Advanced

Install Propeller Guards

Please install the propeller guards according to the steps shown below:

Prepare AP10 aerial photography equipment (1 set), propeller guard (4pcs), M3.0×10 screw (8pcs), and

cross-head screwdriver (1pc).

Use the screwdriver to remove the two screws (M3.0×6) on the motor, as shown in the ovals in the figure below.

Tighten the two screws (M3.0×10) with proper force according to the dash lines shown in the figure below, and

install the four propeller guards. Do not use screw adhesive.

Note: If propeller guards are installed, M3.0×10 screws are used; if propeller guards are not installed, only M3.0×6

screws can be used, because the motors may get damaged if the screws are too long.

First move left the battery lock at the bottom of the aerial photography equipment towards the side with unlocking

design; push the battery case to the bottom by aligning it with the battery compartment; then move right the battery

lock towards the side with locking design.

Notice: Please make sure the power switch is in the OFF state during installation of the battery; after the

battery is installed, the battery lock must be moved to the locking position.

- 8 -

Table of Contents

Show Quick Links

Table of Contents