Alarm Sounds - AEE AP10 User Manual

Usable duration: 3.4h
Charging duration: <2h
1.4 Binding between the repeater and the airborne camera
The repeater is a wireless communication device working at 2.4GHz frequency band, which is used to increase the
effective communication distance between the mobile device and the aerial photography equipment. In an open field
without interference, the effective communication distance can reach 300m or more. The effective communication
distance can be affected by the ambient environment, such as tree sheltering, building reflection and other sources
at the same frequency band. Before flight, please make sure the repeater works normally, or the mobile device will
fail to be connected with the airborne camera. Each repeater has its sole MAC address and service set identifier
(SSID) which are printed on the User Manual of the product; the form of SSID is DW12.
I. Turn on the repeater DW12:
1. Fix the repeater to the corresponding position on the remote control according to the User Manual; make sure
the repeater is firmly fixed.
2. Turn the power switch of the repeater to "ON" position to turn on the repeater.
3. Wait for about 30s; then the WiFi signal indicator (blue) flashes, indicating that the repeater is in normal working
status.
II. Steps for binding the repeater DW12 with the airborne camera:
1. Power on the aerial photography equipment and the remote control to successfully connect the remote control
with the equipment.
2. Turn the slide switch S2 of the remote control to the middle position, and the camera enters the paring mode.
3. Power up the repeater DW12.
4. Wait for about 60s; use a needle-like object to press the binding button of the repeater until the WiFi signal
indicator turns off; then loosen the binding button.
5. Wait for about 30s; then the WiFi signal indicator (blue) flashes (indicating the repeater DW12 has acquired the
SSID and MAC address of the camera), and the repeater enters the binding state; in case of unsuccessful
pairing, please repeat the above steps from Step 3.
6. Find the repeater DW12 in the WiFi list on the mobile device and connect it;
Points for attention:
(1) Please fully charge the repeater before its first use.
(2) When the repeater is in the state of low-voltage alarm (the power indicator quickly flashes in red), it may stop
running at any time; please charge it timely. When the repeater is charged after power-off, the power indicator
slowly flashes in red: 1s on, 2s off; the red light is constantly on when the repeater is fully charged.
(3) Before each outdoor use, please fully charge the repeater to ensure its normal use.
(4) After each use, please remember to power off the repeater.
(5) During flight, please try to align the repeater with the aerial photography equipment to obtain the maximum
communication distance.
(6) The SSID of the repeater can be found in the WiFi list on the mobile phone only when both the camera and the
repeater are powered up and work normally.
(7) Please do not press the binding button at random to avoid binding loss.
Remark: Please re-pair before power up the repeater DW12 or the aerial photography equipment, which will be
resolved per updating software in future.

Alarm Sounds

The aerial photography equipment can make the following alarm sounds:
Working status
Level 2 alarm for low battery of the aerial
Sound definition (different in interval and length)
The arm lights flash quickly with beep sounds: beep beep ---
- 21 -
AEE Aerial Photography Equipment
Professional·Advanced