Trial Flight - AEE AP10 User Manual

AEE Aerial Photography Equipment
Professional·Advanced
"MC" position (manual fly control mode).
3. To switch the fly mode of the aerial photography equipment to GPS mode (if GPS satellite search is normal)
when the flight in manual mode is normal, please first keep the equipment hovering, and then turn S4 to "AC"
position for flight in GPS mode.

Trial Flight

1. First power on the remote control and then the aerial photography equipment; turn the slide switch S1 up to
"OFF", S2 to "OK", S3 to "STOP", and S4 to "MC"; the aerial photography equipment begins to search for
satellites; at this moment, the two front arm lights (green), the two rear arm lights (red), and the tail light (red) turn
on; after successful self-checking, the tail light flashes quickly, and the arm lights are constantly on. When 5
satellites are found, the tail light flashes once every 3s; when 6 satellites are found, the tail light flashes twice
every 3s, and so on and so forth; when 10 or more satellites are found, the tail light flashes six times every 3s.
Satellite search instruction
Number of satellite
Flash frequency of tail light
For outdoor operation of the aerial photography equipment, please do not start the equipment until 6 or more
satellites are found, so as to make sure the aerial photography equipment records the position of HOME point and
prevent the equipment from losing control.
If the aerial photography equipment is forced to take off before 6 satellites are found, the following consequences will
be caused:
1) When it is beyond the operating range, the aerial photography equipment may fail to go back to the take-off
position.
2) When the remote control signals are jammed, the aerial photography equipment may fail to go back to the
take-off position.
3) When switched to the auto fly mode, the aerial photography equipment may not hover at the current position;
what's worse, equipment crash can be caused.
2. For protection, when the aerial photography equipment is powered up, the electronic speed controller will not
start the motors before receiving the control signal. At this moment, unlocking should be carried out first; turn the
joysticks to a lower toe-out shape (as shown in the figure) and loosen them after 3s. The motors must be locked
after the aerial photography equipment lands; turn the joysticks to a lower toe-out shape and loosen them after
3s; then the motors stop running. At this moment, there is no response from the aerial photography equipment
when the joysticks are operated. For restart, also turn the joysticks to a lower toe-out shape to unlock the aerial
photography equipment.
Turn the left joystick to the lower left corner
Motor startup and shutdown
Motor startup: For protection, the motors will not be started up by directly pushing the throttle before take-off. At this
5 6
1 2
- 14 -
7 8
3 4
Turn the right joystick to the lower right corner
9 10 or more
5 6