Start The Aerial Photography Equipment - AEE AP10 User Manual

Turn the left joystick to the upper left corner
3. Calibration of compass: Place the aerial photography equipment on a horizontal plane; at this moment, the rear
lights (red) turn constantly on. Turn the joysticks to an upper toe-in shape (as shown in the figure) until the front
lights (green) begin to flash, and then loosen the joysticks; the aerial photography equipment begins compass
calibration.
Turn the left joystick to the upper right corner
As shown in the figure below, first hold the aerial photography equipment to make it slowly rotate by 360° along the
horizontal plane; then inversely rotate the aerial photography equipment by 360° along the vertical plane of the
equipment; rotate several circles when the green lights are flashing to obtain adequate compass data until the front
lights (green) turn off. Place the aerial photography equipment on a horizontal ground; when the front lights (green) of
the aerial photography equipment turn on, the calibration is finished. During calibration, do not shake or move the
aerial photography equipment.

Start the Aerial Photography Equipment

Fly control modes
The aerial photography equipment has two fly control modes: manual fly control mode ("MC") and GPS fly control
mode ("AC").
1. S4 on the remote control is the mode control switch which can realize the switch between "MC" (manual fly
control mode) and "AC" (GPS fly control mode).
2. It is suggested that S4 should be turned to "MC" position before each flight so that the equipment will take off at
Turn the right joystick to the upper right corner
Turn the right joystick to the upper left corner
- 13 -
AEE Aerial Photography Equipment
Professional·Advanced