Pairing Of Aerial Photography Equipment; Calibration Of Aerial Photography Equipment - AEE AP10 User Manual

Install the batteries in the remote control; slide the power switch rightwards to turn it ON; at this moment, the left
power indicator (red) turns on, and the right recording indicator (blue) turns off 3s after turning on.

Pairing of Aerial Photography Equipment

The aerial photography equipment has undergone pairing before delivery, so it is unnecessary to carry out pairing
again. If paring is indeed necessary, the steps below can be followed:
1. Turn on the power switch of the aerial photography equipment; at this moment, the aerial photography equipment
is started with two "beep" sounds from the motors.
2. When the aerial photography equipment makes "beep" sounds, quickly turn on the remote control; the power
switch indicator (red) turns on; paring begins about 3s after the recording indicator (blue) turns on.
3. After successful pairing, the tail light (red) of the aerial photography equipment flashes quickly, and the airborne
recording indicator (blue) on the remote control turns off.
4. Turn off the aerial photography equipment and the remote control. For restart, first power on the remote control
and then the aerial photography equipment.
5. In case of pairing failure, please repeat Step 1~4.

Calibration of Aerial Photography Equipment

1. Calibration of accelerometer: Place the aerial photography equipment on a horizontal plane for about 1s; turn the
joysticks to a lower toe-in shape until all LED lights on the four arms turn off, and then loosen the joysticks; when
the LED lights turn on again, the calibration of the first plane is finished; the other five planes of the aerial
photography equipment can be calibrated in the same way.
Turn the left joystick to the lower right corner Turn the right joystick to the lower left corner
- 11 -
AEE Aerial Photography Equipment
Professional·Advanced