Install Propellers - AEE AP10 User Manual

AEE Aerial Photography Equipment
Professional·Advanced
Motor
Airborne camera
Right front light
(green)
Right rear light

Install Propellers

There are two clockwise propellers and two counter-clockwise propellers. The propeller caps have two colors: black
and silver. Propellers with black caps are clockwise propellers which should be installed on support arms with "P"
mark. The clockwise propellers should be installed on the left front and right rear support arms of the aerial
photography equipment.
Wrong installation of clockwise and counter-clockwise propellers will inevitably result in errors in the lift
system of the aerial photography equipment, further leading to unpredictable consequences.
1. Place the propellers with black caps on the support arms with "P" mark, and tighten the propellers
counter-clockwise; place the propellers with silver caps on the support arms without "P" mark, and tighten the
propellers clockwise.
2. To remove a propeller, use a hand or auxiliary wrench to make the motor seize up (see the figure below) and
stop rotating; grasp the propeller; rotate the propeller with black cap clockwise to remove the propeller; rotate the
propeller with silver cap counter-clockwise to remove the propeller.
TF card slot
(red)
Tail light (red)
Battery door Power switch
- 6 -
Propeller
Undercarriage
Propeller guard
Left front light
(green)
Left rear light
(red)