Dev Customers; Configuring The Lan Port On Your Bwx-100 Pc For Dhcp - L3 Mobile-Vision BWX-100 User Manual

DEV Customers

If you are running Digital Evidence Viewer (DEV) on a Windows PC, you have three
options to assign IP addresses to your BWX-100s (select one):
1) Configure the Dell PowerConnect Ethernet switch to automatically assign IP
2) Install and Configure a DHCP Server Windows application provided by L3
For customers 3) Configure the LAN port on your BWX-100 PC for DHCP, as described below.
with only one
BWX-100
If you're not sure which option to choose, let us know and we will help you with that
decision. To reach L3 Mobile Vision Support, call 1-800-336-8475 and select the
Service option, followed by Back Office.

Configuring the LAN port on your BWX-100 PC for DHCP

If you are a DEV customer who has only one BWX-100, use this procedure to
configure your PC's LAN port so that it will automatically assign an IP address to
the BWX-100.
NOTE: The following instructions represent Windows 7. If you have a different
version of Windows, this procedure may vary slightly.
1 Locate the Network Icon in the lower right corner of your Windows screen.
2 Right-click on the icon and select Open Network and Sharing Center from the
popup menu.
3 Go to the left side of your screen and select Change adapter settings.
(Continued)
P a g e 32
addresses to your BWX-100s. An L3 Mobile-Vision Technical Support Engineer
can assist you with this task. If you don't have a Dell PowerConnect Ethernet
switch and do not wish to purchase one, select option 2 or 3 instead.
– OR –
Mobile-Vision. An L3 Mobile-Vision Technical Support Engineer can assist you
with this task.
– OR –
This procedure only applies to customers who have one BWX-100. If you have
more than one device, you will have to use option 1 or 2.
Getting Started
BWX-100 User's Guide
L3 Mobile-Vision  5.8.2018