Charging The Bwx-100; Charging Via The Uplink Station - L3 Mobile-Vision BWX-100 User Manual

Charging the BWX-100

The BWX-100 comes with an internal, rechargeable battery. When the battery is very
low, the words BATTERY LOW display on the LCD screen and the Battery icon
appears empty, as pictured left. To recharge the battery, you can either place the
device in one of the docking stations at your agency's Uplink Station, or place it in a
"stand alone" docking station that's connected to a power source.
For more information, see:
 Charging via the Uplink Station, below
 Charging via a Stand-Alone Docking Station, page 23
 Battery Safety & Usage Guidelines, page 23.
WARNING: Do not attempt to remove the BWX's internal battery yourself. Doing so
could void your warranty. When it's time to replace the battery (see guidelines on
page 23), contact L3 Mobile-Vision Service at 1-800-336-8475.

Charging via the Uplink Station

The Uplink Station that you use to upload videos to your storage server doubles
as a charging station. When you return to your precinct after a recording session,
proceed to your agency's Uplink Station and place the BWX-100 in one of the
available docking stations. While your device is charging, the LCD screen displays
the word CHARGING followed by the current battery charge.
When the device is fully charged, the word CHARGED displays on the LCD screen
and the Battery icon appears full, as pictured left.
Charging takes anywhere from a few minutes to a few hours, depending on how much
of a charge the battery had left in it when you placed it in the Uplink Station.
P a g e 22
Operating Procedures
The Battery Charge Indicator shows the
approximate charge remaining on your battery.
The more lines, the greater your charge
BWX-100 User's Guide
L3 Mobile-Vision  5.8.2018