Turning The Device Off; Getting Started - L3 Mobile-Vision BWX-100 User Manual

10 Press the
11 Press the
12 Press the
13 Press the
To turn the BWX-100
off, simultaneously
press the Snap/Trace
and Mute buttons

Getting Started

This section describes how to get up and running with BWX-100. The following is an
overview of the steps involved in setting up the BWX-100 with your DES software.
The specific procedures involved in each of these steps are referenced in various
sections throughout this document.
Make sure that you perform these steps in sequential order.
In collaboration with your agency's Network/IT staff, determine the range of IP
1
addresses that are not currently being used by Flashback DVRs, access points, or
Backup PCs on the L3 Mobile-Vision network. Write this information down, as you
will need it the next time you contact L3 Mobile-Vision Service.
Set up an Uplink Station for your BWX-100s, as pictured in Figures 1 – 3 beginning
2
on page 19. The server switch should contain the network environment for your L3
specific devices (i.e., Flashback DVRs, robotic DVD burner, and wireless access
points). Your agency's Network/IT staff can assist you with this task.
Place your BWX-100 in one of the docking stations in your Uplink Station. Leave it
3
there until the word CHARGED displays, indicating that the device is fully charged.
Select the appropriate DES BWX-100 download options and preferred settings, as
4
described in "Configuring a New BWX-100 DVR in DES" on page 37.
P a g e 30
button. The previous menu redisplays.
 
or button until the word RESULTS displays.
button.
 
or button to scroll through your test results.

Turning the Device Off

To turn your BWX-100 off after a shift or recording session, sim-
ultaneously press the Snap/Trace and Mute buttons until the device
vibrates and the words SHUTTING DOWN display on the LCD
screen. The device then powers off.
Getting Started
BWX-100 User's Guide
L3 Mobile-Vision  5.8.2018