Display Device Selection; Tv Mode - Siemens Mobile 750 Operating Manual

BIOS Setup
32 Bit I/O - Access width for data transfer
This field specifies the I/O access width of data transmission between the processor and the IDE
controller.
Data transfer is performed with 32-bit I/O commands. This enhances performance.
Enabled
Data transfer is performed with 16-bit I/O commands.
Disabled
Transfer Mode
This field specifies the transfer mode for the IDE hard disk drive.
0,8 Mbytes/s to 2 Mbytes/s
Standard
2 Mbytes/s to 4 Mbytes/s
Fast PIO 1
4 Mbytes/s to 5 Mbytes/s
Fast PIO 2
5 Mbytes/s to 10 Mbytes/s
Fast PIO 3
10 Mbytes/s to 13.3 Mbytes/s
Fast PIO 4
Ultra DMA Mode - Access Speed
This field specifies the access speed for the IDE hard disk drive.
slow access speed
Mode 0
middle access speed
Mode 1
fast access speed
Mode 2

Display Device Selection

This field is used to specify the display device.
The notebook's internal display and the external display are used.
LCD&CRT
Just the external display is used.
CRT
Just the internal display is used.
LCD
TV Output is carried out on the TV.
The notebook's internal display and the television are used.
LCD & TV
If the notebook is connected to a MobiDock and an external display is connected to the MobiDock, the
external display is used regardless of the setting in the BIOS Setup (CRT only).

TV Mode

This field is used to specify the display device.
Output on the TV is in the PAL standard.
PAL
Output on the TV is in the NTSC standard.
NTSC
46
Main menu - Making system settings
A26391-K84-Z100-1-7619