Ide Adapter 0 Master/Ide Adapter 1 Master - Hard Disk Drive - Siemens Mobile 750 Operating Manual

BIOS Setup
IDE Adapter 0 Master/IDE Adapter 1 Master -
hard disk drive
These two fields call the submenu to make corresponding settings of the IDE hard disk drives.
You should change the default settings only if you are connecting an additional IDE drive
i
(e.g. CD ROM drive)
The following description of the setting options for IDE Adapter 0 Master also applies to IDE Adapter 0
Slave, IDE Adapter 1 Master and IDE Adapter 1 Slave. The default settings depend on the installed drive.
Phoenix BIOS Setup
Main
IDE Adapter 0 Master (C: 814 MB)
Type Fixed Disk:
Type:
Cylinders:
Heads:
Sectors:
Maximum Capacity:
Multi-Sector Transfers:
LBA Mode Control:
32 Bit I/O:
Transfer Mode:
Ultra DMA Mode:
↑↓
F1 Help Select Item
← →
ESC Exit Select Menu
Example for the submenu IDE Adapter 0 Master
If you have installed a new unformatted IDE hard disk drive, you should mark the Type Fixed Disk field
and press the Enter key. This has the effect of setting the optimum values for the IDE hard disk drive.
You can change these values if you set the Type field to User.
If you install a formatted hard disk drive, the values are set automatically.
44
[Press Enter]
[Auto] 814 Mb
1579
16
63
16 Sectors
Enabled
[Enabled]
Fast PIO 3
[Disabled]
Space Change Values
²
Enter Select Sub-Menu
Main menu - Making system settings
Item Specific Help
F9 Setup Defaults
F10 Previous Values
A26391-K84-Z100-1-7619