Table of Contents
Advertisement
(1) Example of a specified special print
Use the tools to generate special image prints and then select
(2) Trimming and release of the range to be magnified/reduced
To perform trimming processing of the range to be magnified/reduced, select on the displayed image
a position that is to be used for the start point, and then select the end point so that a rectangle is
shaped as the range for trimming.
To release trimming processing, select
(3) Assigning a trimmed image into a film format and its release
Confirm the frame printed in bold-face in the image format display field. (The area within this frame
is targeted for assigning the trimmed image.)
To change the frame where the trimmed image is to be assigned, select the other frame for the
assignment.
Perform trimming of a range you want to magnify/reduce on the displayed image, and then select
.
If
is selected, the image appearing in the image format display field in bold-face will then be
released.
2009. 09 897N0519H
.
.
CR Console Operation Manual
4 - 51
Advertisement
Table of Contents
