Table of Contents
Advertisement
■ Further information for IEC 60601-1-2
(1) Medical electrical equipment is subject to special precautions regarding EMC. The equipment must be
installed and put into service according to the EMC information provided in Tables 1 to 4.
(2) Portable and mobile RF communications equipment can affect medical electrical equipment.
(3) Information regarding the cable affecting EMC is as follows.
Name
Network Cable
(4) The use of accessories, transducers and cables other than those specified, with the exception of
transducers and cables sold by FUJIFILM Corporation as replacement parts for internal components,
may result in increased emissions or decreased immunity of the equipment.
(5) The equipment should not be used adjacent to or stacked with other equipment.
If adjacent or stacked use is necessary, the equipment should be observed to verify normal operation
in the configuration in which it will be used.
(6) Test items (Tables 1 to 4)
Table 1
Guidance and manufacturer's declaration - electromagnetic emissions
The CR-IR 348CL is intended for use in the electromagnetic environment specified below.
The customer or the user of the CR-IR 348CL should assure that it is used in such an environment.
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations / flicker
emissions
IEC 61000-3-3
2010. 03 897N0519J
General Specification
Cat5e or more, UTP type and
straight cable
Compliance
Electromagnetic environment - guidance
The CR-IR 348CL uses RF energy only for its internal
function. Therefore, its RF emissions are very low and are
Group 1
not likely to cause any interference in nearby electronic
equipment.
Class A
The CR-IR 348CL is suitable for use in all establishments
other than domestic and those directly connected to the
Class D
public low-voltage power supply network that supplies
buildings used for domestic purposes.
Does not
comply
CR Console Operation Manual
1 - 5
Advertisement
Table of Contents
