Nokia 7368 Product Manual page 108

Configure a G-240W-G indoor ONT
(2 of 2)
2
3
4
Procedure 26
1
108
Release 05.08.01a | August 2018 | Edition 01
Field
WAN Interface
Primary Remote End
Secondary Remote End (optional)
Connected Remote End
Failover mechanism
Traffic timeout to start pings
No. of retries before unreachable
Configure the GRE tunnel by entering or selecting the required information.
Click Save.
STOP. This procedure is complete.
QoS configuration
Select Network > QoS Config from the top-level menu in the Home Gateway window.
Figure 42 shows the window for configuring QoS L2 (Layer 2 packet sizes).
3FE-47555-AAAA-TCZZA
7368 ISAM ONT G-240W-G Product Guide
Description
Choose a WAN interface from the drop-down menu.
GRE tunnels can only be created on HSI-enabled WAN interfaces.
Enter an IP address or FQDN that is unique in the system.
If the primary remote endpoint is down or unreachable, the secondary
remote endpoint becomes active, if configured.
The secondary remote endpoint remains active until it becomes
unreachable, in which case the primary remote endpoint becomes active
again. Revertive mode is not supported.
If both endpoints are unreachable, the GRE tunnel is declared down.
This field displays the current data traffic path for the GRE tunnel.
This feature is automatically selected by the system.
Enter the traffic timeout in seconds (0 to 100).
Enter the number of retries before the tunnel is declared down (2 to 1024).
Issue: 01