Nokia 7368 Product Manual page 69

7368 ISAM ONT G-240W-G Product Guide
10
11
12
13
14
15
16
17
Issue: 01
Release 05.08.01a | August 2018 | Edition 01
Connect the fiber optic cable with SC/APC adapter into the SC/APC connector. Figure
shows the location of the SC/APC connector.
Danger — Fiber cables transmit invisible laser light. To avoid eye
damage or blindness, never look directly into fibers, connectors, or
adapters.
Warning — Be careful to maintain a bend radius of no less than 1.5 in.
(3.8 cm) when connecting the fiber optic cable. Too small of a bend radius
in the cable can result in damage to the optic fiber.
Note — Fiber cable preparation varies depending on the type and size
of the inside or outside plant fiber cable being spliced to the SC/APC fiber
optic pigtail cable.
Install the power supply according to manufacturer specifications.
Note — Observe the following:
•
Units must be powered by a Listed or CE approved and marked
limited power source power supply with a minimum output rate of
12 VDC, 3 A.
Connect the power cable to the power connector.
Power up the unit by using the power switch.
If used, enable the Wi-Fi service by pressing the WLAN button; see Figure
of the WLAN button.
If used, configure the SLID; see the 7368 ISAM ONT Configuration, Management, and
Troubleshooting Guide for more information.
Note — A new SLID or the old SLID may be used with the replacement
ONT. If a new SLID is used, the new SLID must also be programmed at
the P-OLT using TL1 or a network manager. If the old SLID is used, no
changes need to be made at the P-OLT; see the operations and
maintenance documentation for the OLT for more details.
Verify the ONT LEDs, voltage status, and optical signal levels; see the 7368 Hardware and
Cabling Installation Guide.
Activate and test the services; see the 7368 Hardware and Cabling Installation Guide.
3FE-47555-AAAA-TCZZA
Replace a G-240W-G indoor ONT
17 for the location
17
69