Device Installation - Concox GT03C User Manual

(4) The device can work normally during charging. Red LED being light indicates that it is charging.
When charging is finished, red LED will flash slowly.
Warning: the ambient temperature shall be 0℃～40℃ while charging. Please use the charger
provided by the manufacturer.
3.4 Device installation
The device has a strong magnet in rear cover which could attach to any mental surface.
The recommended installation position is as follows;
(1) Below the front windshield with the device front up and make sure there are no sunshade mask
and other anti-GPRS reception material on it
(2) On the bottom of a car such as the side place below door. Do not put it too far inside, otherwise
it can not receive GPS signal.
Note:
1. Device should be in the place with good GPS reception.
2. Do not put the device in some place where may get rusty easily.
3. Do not put the device in some place with extremely high temperature, such as around the
radiator pipe or exhaust port, for that it may lower the magnetism greatly.
4. To place the device under the car, please make sure GPS is located first.
5. Do not use for portable
6. The location for installation of this device at more than 20cm away from passengers (front
or rear) or bystanders.