Mode3: Locating According To Command; Troubleshooting - Concox GT03C User Manual

LBS location.
In this mode, if the terminal does not detect any vibration, GPS will be off. And after it detects vibration, it will
start working again.
Send SMS command:
mode,2#
5.3 Mode3: Locating according to command
In this mode, the terminal will be in Deep Sleep mode. It will not connect with the platform. You can send SMS
command/call to activate checking location function. During this mode, arm/disarm will not be executed. It will
reply: "The terminal is in Deep Sleep mode. Please wake up!"
Send SMS command:
mode,3#
6 Appendix
6.1 Battery security
● Please use the original battery. The warranty will be invalid by using any other accessory. The
manufacturer will not take any responsibility for any damage caused by not using the original
battery.
● The new battery can realize the optimal performance after fully- charging for 2 or 3 times.
● The battery can be used for hundreds of times, yet it will wear out eventually. When its talking
time and standby time shrinks sharply, you need a new one.
● Cut off power supply when not using the charger. Don't charge the battery for more than one
week, since over charging will reduce its using time.
● Do not short-circuit the battery with metal stuff (such as the key in your pocket)
● Do not bend or open the battery.
● Do not put the battery into water or fire.
● The battery should never be charged at temperature below 0 degrees or above 45 degrees
Celsius.
6.2 Trouble shooting
If there is any problem while operating the terminal, please refer to the following table, or
contact your service provider.
Common problems Causes Solution